Painless-performance VORTEC 60211 Manual de usuario

P/N 60211, 60216 1996-2000 GM VORTEC 7.4 FUEL INJECTION WIRE HARNESS INSTALLATION INSTRUCTIONS Manua

6.3.5 Engine Section Connections WIRE COLOR # OF POSITIONS LABELED CONNECT TO:

9 FIGURE 6.6 Knock Sensor Connector FIGURE 6.7 Oxygen Sensors FIGURE

10 FIGURE 6.11 Injectors 1 - 8 FIGURE 6.12 Coil Driver (Component is pictured on a 5.7.

6.4 TAIL SECTION INSTALLATION 6.4.1 Locate the tail section that you earlier separated from the engine group. Begin routing it tow

FIGURE 6.19 A/T Input Speed & VSS Sensor, Transmission Connection (4L80E) 7.0 TROUBLE- SHOOTING INSTRUCTIONS If you are having trouble

7.2 RETRIEVING TROUBLE CODES FROM THE COMPUTER 7.2.1 In order to retrieve the trouble codes stored in the computer, a scanner must be connected to

We have attempted to provide you with the most accurate instructions possible, and are always concerned about corrections or improvements that can b

TABLE OF CONTENTS 1.0 INTRODUCTION...

1.0 INTRODUCTION You have purchased what we at Painless Performance Products believe to be the most up-to-date and easiest-to-install automotive fue

3.0 TOOLS NEEDED In addition to your regular tools, you will need, at least, the following: Crimping tool NOTE: USE A QUALITY TOOL TO A

4.2.6 Route the harness away from sharp edges, exhaust pipes, and the hood, trunk and door hinges. 4.2.7 Plan where harness supports will be locate

5.1 GROUNDING THE VEHICLE A perfectly and beautifully wired automobile will never the less have problems if everything is not properly grounded. Don

5.4.4 Strip insulation away from wire. Only strip as much insulation off as necessary for the type of terminal lug you are using. Note: In the foll

A. Find a suitable location to mount the DLC connector (using the bracket that the light is mounted in) that will allow access to the front of

F. If your vehicle has a pressure type brake switch, you may use a relay as shown in Figure 6.3. The relay must be a SPDT Relay and wired correctly o